Cisco交换机基本命令配置大全Word文档下载推荐.docx
- 文档编号:15069165
- 上传时间:2022-10-27
- 格式:DOCX
- 页数:15
- 大小:20.23KB
Cisco交换机基本命令配置大全Word文档下载推荐.docx
《Cisco交换机基本命令配置大全Word文档下载推荐.docx》由会员分享,可在线阅读,更多相关《Cisco交换机基本命令配置大全Word文档下载推荐.docx(15页珍藏版)》请在冰豆网上搜索。
3.在基于IOS的交换机上设置远程访问:
switch(config)#interfacevlan1
switch(config-if)#ipaddressip-addressnetmask
switch(config-if)#ipdefault-gatewayip-address
在基于CLI的交换机上设置远程访问:
switch(enable)setinterfacesc0ip-addressnetmaskbroadcast-address
switch(enable)setinterfacesc0vlan
switch(enable)setiproutedefaultgateway
4.在基于IOS的交换机上启用和浏览CDP信息:
switch(config-if)#cdpenable
switch(config-if)#nocdpenable
为了查看Cisco邻接设备的CDP通告信息:
switch#showcdpinterface[typemodle/port]
switch#showcdpneighbors[typemodule/port][detail]
在基于CLI的交换机上启用和浏览CDP信息:
switch(enable)setcdp{enable disable}module/port
switch(enable)showcdpneighbors[module/port][vlan duplex capabilities detail]
5.基于IOS的交换机的端口描述:
switch(config-if)#descriptiondescription-string
基于CLI的交换机的端口描述:
switch(enable)setportnamemodule/numberdescription-string
6.在基于IOS的交换机上设置端口速度:
switch(config-if)#speed{10 100 auto}
在基于CLI的交换机上设置端口速度:
switch(enable)setportspeedmoudle/number{10 100 auto}
switch(enable)setportspeedmoudle/number{4 16 auto}
7.在基于IOS的交换机上设置以太网的链路模式:
switch(config-if)#duplex{auto full half}
在基于CLI的交换机上设置以太网的链路模式:
switch(enable)setportduplexmodule/number{full half}
8.在基于IOS的交换机上配置静态VLAN:
switch#vlandatabase
switch(vlan)#vlanvlan-numnamevla
switch(vlan)#exit
switch#configureteriminal
switch(config)#interfaceinterfacemodule/number
switch(config-if)#switchportmodeaccess
switch(config-if)#switchportaccessvlanvlan-num
switch(config-if)#end
在基于CLI的交换机上配置静态VLAN:
switch(enable)setvlanvlan-num[namename]
switch(enable)setvlanvlan-nummod-num/port-list
9.在基于IOS的交换机上配置VLAN中继线:
switch(config)#interfaceinterfacemod/port
switch(config-if)#switchportmodetrunk
switch(config-if)#switchporttrunkencapsulation{isl dotlq}
switch(config-if)#switchporttrunkallowedvlanremovevlan-list
switch(config-if)#switchporttrunkallowedvlanaddvlan-list
在基于CLI的交换机上配置VLAN中继线:
switch(enable)settrunkmodule/port[on off desirable auto nonegotiate]
Vlan-range[isl dotlq dotl0 lane negotiate]
10.在基于IOS的交换机上配置VTP管理域:
switch(vlan)#vtpdomaindomain-name
在基于CLI的交换机上配置VTP管理域:
switch(enable)setvtp[domaindomain-name]
11.在基于IOS的交换机上配置VTP模式:
switch(vlan)#vtp{sever cilent transparent}
switch(vlan)#vtppasswordpassword
在基于CLI的交换机上配置VTP模式:
switch(enable)setvtp[domaindomain-name][mode{sever cilent transparent}][passwordpassword]
12.在基于IOS的交换机上配置VTP版本:
switch(vlan)#vtpv2-mode
在基于CLI的交换机上配置VTP版本:
switch(enable)setvtpv2enable
13.在基于IOS的交换机上启动VTP剪裁:
switch(vlan)#vtppruning
在基于CLI的交换机上启动VTP剪裁:
switch(enable)setvtppruningenable
14.在基于IOS的交换机上配置以太信道:
switch(config-if)#portgroupgroup-number[distribution{source destination}]
在基于CLI的交换机上配置以太信道:
switch(enable)setportchannelmoudle/port-rangemode{on off desirable auto}
15.在基于IOS的交换机上调整根路径成本:
switch(config-if)#spanning-tree[vlanvlan-list]costcost
在基于CLI的交换机上调整根路径成本:
switch(enable)setspantreeportcostmoudle/portcost
switch(enable)setspantreeportvlancostmoudle/port[costcost][vlan-list]
16.在基于IOS的交换机上调整端口ID:
switch(config-if)#spanning-tree[vlanvlan-list]port-priorityport-priority
在基于CLI的交换机上调整端口ID:
switch(enable)setspantreeportpri{mldule/port}priority
switch(enable)setspantreeportvlanpri{module/port}priority[vlans]
17.在基于IOS的交换机上修改STP时钟:
switch(config)#spanning-tree[vlanvlan-list]hello-timeseconds
switch(config)#spanning-tree[vlanvlan-list]forward-timeseconds
switch(config)#spanning-tree[vlanvlan-list]max-ageseconds
在基于CLI的交换机上修改STP时钟:
switch(enable)setspantreehellointerval[vlan]
switch(enable)setspantreefwddelaydelay[vlan]
switch(enable)setspantreemaxageagingtiame[vlan]
18.在基于IOS的交换机端口上启用或禁用PortFast特征:
switch(config-if)#spanning-treeportfast
在基于CLI的交换机端口上启用或禁用PortFast特征:
switch(enable)setspantreeportfast{module/port}{enable disable}
19.在基于IOS的交换机端口上启用或禁用UplinkFast特征:
switch(config)#spanning-treeuplinkfast[max-update-ratepkts-per-second]
在基于CLI的交换机端口上启用或禁用UplinkFast特征:
switch(enable)setspantreeuplinkfast{enable disable}[rateupdate-rate][all-protocolsoff on]
20.为了将交换机配置成一个集群的命令交换机,首先要给管理接口分配一个IP地址,然后使用
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Cisco 交换机 基本 命令 配置 大全