juniperHA官方图样和各种板卡安装图样.docx
- 文档编号:30748088
- 上传时间:2023-08-20
- 格式:DOCX
- 页数:12
- 大小:1.49MB
juniperHA官方图样和各种板卡安装图样.docx
《juniperHA官方图样和各种板卡安装图样.docx》由会员分享,可在线阅读,更多相关《juniperHA官方图样和各种板卡安装图样.docx(12页珍藏版)》请在冰豆网上搜索。
juniperHA官方图样和各种板卡安装图样
Thecontrollinkreliesonaproprietaryprotocoltotransmitsessionstate,configuration,andlivelinesssignalsacrossthenodes.OnSRX5600andSRX5800devices,bydefault,allcontrolportsaredisabled.EachSPC
inadevicehastwocontrolports,andeachdevicecanhavemultipleSPCspluggedintoit.TosetupthecontrollinkinachassisclusterwithSRX5600orSRX5800devices,youconnectandconfigurethecontrolportsthatyouwilluseoneachdevice(fpcnandfpcn)andtheninitializethedeviceinclustermode.
ForSRX3400andSRX3600devices,therearededicatedchassiscluster(HA)controlportsontheswitchfabricboard.NocontrollinkconfigurationisneededforSRX3400andSRX3600devices.
ForSRX650andSRX240devices,thecontrollinkusesthege-0/0/1interface.
ForSRX210andSRX100devices,thecontrollinkusesthefe-0/0/7interface.
InaJSerieschassiscluster,thecontrollinkisaphysicalconnectionbetweenthege-0/0/3
portsoneachdevice,withbothtransformedintofxp1.
Fordetailsaboutportandinterfaceusageformanagement,control,andfabriclinks,see
Table80onpage848andTable81onpage854.
TosetupthecontrollinkonJSeriesdevices,youconnectthecontrolinterfacesonthe
twodevicesback-to-back.Whenyouinitializeadeviceinclustermode,JunosOSrenames
thecontrolinterfacetofxp1andusesthatinterfacefortheclustercontrollink.Toenable
thecontrollinktotransmitdata,thesystemprovideseachfxp1controllinkinterfacewith
aninternalIPaddress.
SRX3600和SRX3400使用相同的SPC(注:
系
统正常运行至少需要1个NPC和1个SPC)。
SRX3400ServicesGatewaysinarackthathasatleast40U(70in.or1.78m)ofusable
verticalspace.
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- juniperHA 官方 图样 各种 板卡 安装