发电机检测(中英文对照)文档格式.doc
- 文档编号:15503366
- 上传时间:2022-11-02
- 格式:DOC
- 页数:4
- 大小:48.50KB
发电机检测(中英文对照)文档格式.doc
《发电机检测(中英文对照)文档格式.doc》由会员分享,可在线阅读,更多相关《发电机检测(中英文对照)文档格式.doc(4页珍藏版)》请在冰豆网上搜索。
最小长度
1.5mm(0.059in.)
1.5mm(0.059in.)
Iftheexposedlengthislessthantheminimum,neplacethegeneratorbrushholderassembly.
如果碳刷长度小于最小值,替换发电机的碳刷装置。
2.
INSPECTGENERATORREGULATORASSEMBLY
检查发电机调节器装配
Usinganohmmeter,checkthecontinuitybetweenterminalsFanB
(
a
)使用欧姆表,检查F与
B之间的是否连通。
Standard:
标准.
WhenthepositiveandnegativepolesbetweenterminalsFandBareexchanged,thereiscontinuityinonedirectionbutnocontinuityintheotherdirection..
当F和B之间的正极和负极被交换时,有在一个方向是连通的,但是在另一个方向的没有连通的。
Ifthecontinuityisnotasspecified,replacethegeneratorregulatorassembly.
如果不是规定的连通值,替换发电器调节器装配
(b)
Usinganohmmeter,checkthecontinuitybetweenterminalsFandE.
b
)使用欧姆表,检查F与E之间是否连通。
标准:
WhenthepositiveandnegativepolesbetweenterminalsFandEareexchanged,thereiscontinuityinonedirectionbutnocontinuityintheotherdirection.
3.
INSPECTGENERATORDRIVEENDFRAME
检查发动机定子线圈
Checkthestatorcoilforopencircuits.
检查定子线圈的开路。
(1)Usinganohmmeter,checktheresistancebetweenthecoilleads.
1
)用欧姆表,检查电阻线圈之间的电阻。
Standardresistance:
标准电阻:
Below1Ω
低于1Ω
Iftheresultisnotasspecified,replacethegeneratorassembly.
如果不是规定电阻值,替换发电器定子线圈装配
Inspectthestatorforground..
检查定子线圈是否接地。
(1)
Usinganohmmeter,checktheresistancebetweenthecoilleadanddriveendframe.
使用欧姆计,检查定子线圈与发动机壳体的电阻、
10KΩ
orhigher
10KΩ或更高
(c)
Inspectthebearing.
c
)检查轴承。
Makesurethatthebearingisnotroughorworn.
轴承是否粗糙或磨损过度。
Ifnecessary,replacethegeneratorassembly.
如果有必要,替换发电器装配。
4
INSPECTGENERATORHOLDERWITHRECTIFIER
4检查发电机整流器
Usinganohmmeter,checkthecontinuityamongterminalsP1,P2,P3andB,andamongP1,P2,P3andE.
使用欧姆计,检查P1、P2、P3和B之中和在P1、P2、P3和E之中是否连通
标准
WhenthepositiveandnegativepolesamongterminalsP1,P2,P3andBareexchanged,thereiscontinuityinonedirectionbutnocontinuityintheotherdirection..
当P1、P2、P3和B之中的正极和负极交换时,有在一个方向是连通的,但是在另一个方向没有连通。
WhenthepositiveandnegativepolesamongterminalsP1,P2,P3andEareexchanged,thereiscontinuityinonedirectionbutnocontinuityintheotherdirection..
当P1、P2、P3和E之中的正极和负极被交换时,有在一个方向的连通的,但是在另一个方向没有连通。
Ifthecontinuityisnotasspecified,replacethegeneratorholderwithrectifier.
如果不是规定的连通值,将替换发电机整流器。
5.
INSPECTGENERATORROTORASSEMBLY
5
。
检查发电机转子装配
Checkthegeneratorrotorforopencircuits.
一)检查发电机转子开路。
Usinganohmmeter,measuretheresistancebetweenthesliprings.
)用欧姆表,测量的滑环之间的电阻。
1.7to2.1
Ω
at20º
C(68º
F)
在20º
C(68º
F)的情况下1.7到2.1Ω
Iftheresistanceisnotasspecified,replacethegeneratorrotorassembly.
如果不是规定电阻值,替换发电器转子装配
Checkthegeneratorrotorforshortcircuits.
(二)检查发电机转子的短路。
Usinganohmmeter,checktheresistancebetweentheslipringandgeneratorrotorassembly.
)用欧姆表,检查滑环和发电机转子之间的电阻。
10KΩ
10KΩ或更高
Iftheresultisnotasspecified,replacethegeneratorrotorassembly.
Inspectthesliprings.
)检查的滑环。
Makesurethattheslipringsarenotroughorscored.
)滑环不否粗糙或磨损过度。
Ifroughorscored,replacethegeneratorrotorassembly.
如果粗糙或磨损过度,替换发电器电动机滑环装配
(2)
Usingverniercalipers,measuretheslipringdiameter.
2
)用卡尺,测量滑环的直径。
Standarddiameter:
标准直径:
14.2to14.4mm(0.559to0.567in.)
14.2至14.4毫米(
0.559至0.567英寸
Minimumdiameter:
最小直径:
12.8mm(0.504in.)
12.8mm(
0.504英寸)
Ifthediameterislessthantheminimum,replacethegeneratorrotorassembly.
如果直径小于最小值,替换发电器电动机滑环装配。
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 发电机 检测 中英文 对照