消防产品型式认可申请书样本Word文件下载.docx
- 文档编号:13673847
- 上传时间:2022-10-12
- 格式:DOCX
- 页数:10
- 大小:23.64KB
消防产品型式认可申请书样本Word文件下载.docx
《消防产品型式认可申请书样本Word文件下载.docx》由会员分享,可在线阅读,更多相关《消防产品型式认可申请书样本Word文件下载.docx(10页珍藏版)》请在冰豆网上搜索。
申请企业名称/Applicationproductcategory:
(加盖公章/Seal)
生产厂名称/Factory:
申请产品类别/CategoryofProduct:
填报日期/SubmissionDate(yyyy/mm/dd):
年月日
公安部消防产品合格评定中心印制
PublishedbyChinaCertificationCenterforFireProducts,MinistryofPublicSecurity,PRC
申请企业须知
1、申请企业必须严格按照《消防类产品型式认可实施规则》中工厂基本条件的要求建立并实施有效的质量管理,确保企业的质量保证能力符合实施规则的基本要求;
2、申请企业必须符合《消防类产品型式认可实施规则》中生产设备及检验设备的最低配置要求;
3、申请企业须严格遵守型式认可程序及时限要求,正常情况下,接到工厂检查通知后的30日内应接受工厂条件检查,并应在规定时间内完成对不符合项的整改工作,自抽样之日起15日内将样品送到指定检测机构进行检验,并按期缴纳相关费用;
如遇特殊原因,必须及时通报公安部消防产品合格评定中心;
4、申请企业获证后,必须严格按照《消防类产品型式认可实施规则》的规定,正确使用型式认可证书和标志。
对有违规者,公安部消防产品合格评定中心将进行严肃处理。
5、申请企业获证后,所生产及销售的产品必须与发证检验样品保持一致,产品质量必须符合型式认可规则和相关标准要求。
若必须对涉及产品一致性的关键因素,如关键原器件、原材料、关键设计及主要生产工艺发生变更,以及生产场地搬迁、法人及主要技术人员发生变更时,获证企业必须及时向公安部消防产品合格评定中心申报,由中心按照《消防类产品型式认可实施规则》要求安排确认工作。
未经中心确认,不得生产及销售产品,对违规者,公安部消防产品合格评定中心将进行严肃处理,由此而导致的一切责任均由违规企业承担。
TheNoticeoftheApplicant
1.TheApplicantmustnotonlyconstituteaqualitycontrolandbringintoeffectwhichaccordingtotherequestofthefactory’spostulate,butalsomakesurethequalityguaranteecapacityofthecorporationaccordingtotherequestoftheimplementrules.
2.Theapplicantmustmeasureupthelowestconfigurationrequirementofproducingequipmentandcheckingequipmentthatreferstothe《TheImplementRulesOfThefirefightingproductType-Approval》.
3.Theapplicantmustfollowtheauthenticationprocedureandthetimelimitrequirement.Innormalcondition,theenterpriseshouldaccepttheworkconditioninspectionwithin30daysafterreceivetheinformation,andfinishthemodificationoftheunaccepteditemwithinstatedtime.Theenterpriseshouldsendthesampletotheappointedexamineinstitutionin15daysaftertheinspection,andpayfortherelatedbill.TheenterpriseshoulddeclaretoCCCFintimeifthereisanyspecialcase.
4.Aftergettingthecertificate,theapplicantmustfollowtheimplementrulesstrictlyanduseauthorizedcertificateandsymbolcorrectly.CCCFwillsternlypunishthefoul.
5.Aftergettingthecertificate,theapplicantmustkeeptheproductstheyproduceandsellthesamewiththeinspectingsamples.Thequalityoftheproductsmustmeasureuptheauthenticationregulationsandthecorrelativestandards.Ifthesomekeyfactorsthatrelatedtothecoherenceoftheproductshavetobemodified,suchaskeysourceapparatus,rawmaterial,coredesignandprimaryproducetechnique,aswellastheworkplace,juridicalpersonandkeytechnicalpersonnelchange,theenterprisemustdeclaretoCCCF.AndCCCFvalidatesthesituationaccordingtotheimplementrules.Theenterprisecan'
tproduceandsellanyproductswithoutthevalidation.CCCFwillsternlypunishthefoul.Andthefoulischargedofallthecorrelativeobligation.
声明
我代表申请企业郑重声明:
1.本企业遵循“诚信第一”的基本原则,承诺遵守国家有关法律法规及公安部消防产品合格评定中心(以下简称CCCF)制定的型式认可实施规则的所有要求及型式认可程序。
2.本企业同意按型式认可规则的要求提供评价所需文件和资料,所提供的信息均真实有效,否则承担由此引起的一切法律责任。
3.本企业保证按型式认可合同及相关要求支付型式认可费用,并为实施型式认可产品型式认可工作提供所需要的资源。
4、本企业将妥善保管检验报告、工厂检查报告和型式认可变更确认等型式认可的相关资料,以备监督检查、飞行检查及有关证后监督工作时使用,公安部消防产品合格评定中心将不承担获得产品合格型式认可的生产厂或销售商应承担的法律责任。
5、本企业完全接受《申请企业须知》中所涉及的全部内容。
Statement
I,onthebehalfoftheApplicant,makethestatementhereby:
1.TheApplicantiswillingtocomplywiththeImplementRulesforType-ApprovalformulationwhichbyChinaCertificationCenterforFireProducts(So-calledasCCCF).
2.TheApplicantdoesagreetosubmitthenecessarydocumentsandinformationwhichtruthfulnesshasbeenensuredbytheApplicant,Fromthisotherwiseundertakesalllegalliabilitywhichcauses.
3.TheApplicantguaranteetomakethepaymentinaccordancewiththeType-ApprovalContractand/ortherelevantrequirement.
4.TheApplicantwillkeepingtherelevantinformationaboutauthenticationproperly,suchastheprovereport,jerquereportoffactoryandthevalidateoftheauthenticationchange,whichwillbeusedinthesuperviseinspect,suddeninspectandthesupervisaltaskafterapplication.CCCFwillnottoethescratchwhichmustbebearedbythefactoryormerchantwhogettheproducteligibilityauthentication.
5.TheApplicantdoesacceptthecontents《ThenoticeoftheApplicant》contained.
申请企业法定代表人/AuthorizedPersonoftheApplicantFirm:
(签名Signature/盖章Seal)
日期/Date(yyyy/mm/dd):
一、申请企业名称、地址及联系方式
ApplicantInformation
1申请企业/ApplicantFirm:
1.1申请企业名称/NameinChineseandEnglish:
1.2申请人地址、邮编/MailingAddressandPostcode:
注册地址Registrationaddress:
邮编:
通讯地址Mailingaddress:
1.3法定代表人/JuridicalPerson:
电话/Telephone:
手机/Mobilephone
1.4联系人/PersontobeContacted:
电话/Telephone:
1.5传真/Fax:
1.6电子邮件/E-mail:
1.7组织机构代码/Organizationsandagenciescode:
1.8组织性质代码/Organizationnaturecode:
(按本申请书第六项的要求填写)
2制造商/Manufacturer
2
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 消防产品 型式 认可 申请书 样本